Re: Internet sem fio não funciona

[sabrinadfs]

Pessoal,

Estou com o mesmo problema, sou novata e instalei o Ubuntu 10.10, mas a wireless não funciona, nem liga a luz da wireless...
Executei os comandos indicados e o resultado foi:

sabrina@sabrina-Inspiron-1525:~$ sudo lshw -C network
SCSI                     
  *-network       
       description: Ethernet interface
       product: 88E8040 PCI-E Fast Ethernet Controller
       vendor: Marvell Technology Group Ltd.
       physical id: 0
       bus info: pci@0000:09:00.0
       logical name: eth0
       version: 12
       serial: 00:1e:c9:f9:c1:19
       capacity: 100MB/s
       width: 64 bits
       clock: 33MHz
       capabilities: pm msi pciexpress bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd autonegotiation
       configuration: autonegotiation=on broadcast=yes driver=sky2 driverversion=1.28 firmware=N/A latency=0 link=no multicast=yes port=twisted pair
       resources: irq:43 memory:fe8fc000-fe8fffff ioport:de00(size=256)
  *-network
       description: Network controller
       product: BCM4312 802.11b/g LP-PHY
       vendor: Broadcom Corporation
       physical id: 0
       bus info: pci@0000:0b:00.0
       version: 01
       width: 64 bits
       clock: 33MHz
       capabilities: pm msi pciexpress bus_master cap_list
       configuration: driver=b43-pci-bridge latency=0
       resources: irq:17 memory:fe7fc000-fe7fffff
  *-network DISABLED
       description: Wireless interface
       physical id: 2
       logical name: wlan0
       serial: 00:22:68:b6:e1:e8
       capabilities: ethernet physical wireless
       configuration: broadcast=yes driver=b43 driverversion=2.6.35-22-generic firmware=N/A link=yes multicast=yes wireless=IEEE 802.11bg

sabrina@sabrina-Inspiron-1525:~$ iwconfig wlan0
wlan0     IEEE 802.11bg  ESSID:off/any 
          Mode:Managed  Access Point: Not-Associated   Tx-Power=0 dBm   
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Power Management:off


sabrina@sabrina-Inspiron-1525:~$ ifconfig -a
eth0      Link encap:Ethernet  HWaddr 00:1e:c9:f9:c1:19 
          UP BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
          Interrupt:16

lo        Link encap:Local Loopback 
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:436 errors:0 dropped:0 overruns:0 frame:0
          TX packets:436 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:33904 (33.9 KB)  TX bytes:33904 (33.9 KB)

wlan0     Link encap:Ethernet  HWaddr 00:22:68:b6:e1:e8 
          BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)


sabrina@sabrina-Inspiron-1525:~$ nm-tool

NetworkManager Tool

State: disconnected

- Device: eth0 -----------------------------------------------------------------
  Type:              Wired
  Driver:            sky2
  State:             unavailable
  Default:           no
  HW Address:        00:1E:C9:F9:C1:19

  Capabilities:
    Carrier Detect:  yes

  Wired Properties
    Carrier:         off


- Device: wlan0 ----------------------------------------------------------------
  Type:              802.11 WiFi
  Driver:            b43
  State:             unavailable
  Default:           no
  HW Address:        00:22:68:B6:E1:E8

  Capabilities:

  Wireless Properties
    WEP Encryption:  yes
    WPA Encryption:  yes
    WPA2 Encryption: yes

  Wireless Access Points



Por favor, alguém me diga o que posso fazer!

[zekkerj]

Sabrina, você se importa em aguardar a solução do problema do Danilo?

[clcampos]

Você já trata disto aqui.

Favor tratar de um tema em apenas um tópico. Essa mensagem é duplicada e foi trancada.