Aparece as redes wireless normalmente, coloco a senha e nunca funciona. O que pode estar acontecendo?
Obs: os logs foram feitos com o cabo de rede conectado.sudo lshw -C network*-network
description: Ethernet interface
product: 191 Gigabit Ethernet Adapter
vendor: Silicon Integrated Systems [SiS]
physical id: 4
bus info: pci@0000:00:04.0
logical name: eth0
version: 02
serial: 00:23:5a:55:1b:87
size: 100MB/s
capacity: 100MB/s
width: 32 bits
clock: 33MHz
capabilities: pm bus_master cap_list ethernet physical tp mii 10bt 10bt-fd 100bt 100bt-fd autonegotiation
configuration: autonegotiation=on broadcast=yes driver=sis190 driverversion=1.3 duplex=full ip=192.168.1.101 latency=0 link=yes multicast=yes port=MII speed=100MB/s
resources: irq:19 memory:d4407000-d440707f ioport:1080(size=128)
*-network
description: Wireless interface
product: BCM4312 802.11b/g
vendor: Broadcom Corporation
physical id: 0
bus info: pci@0000:02:00.0
logical name: eth1
version: 01
serial: 00:23:08:73:34:2b
width: 64 bits
clock: 33MHz
capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless
configuration: broadcast=yes driver=wl0 driverversion=5.60.48.36 latency=0 multicast=yes wireless=IEEE 802.11bg
resources: irq:18 memory:d4100000-d4103fff
iwconfig wlan0wlan0 No such device
ifconfig -aeth0 Link encap:Ethernet Endereço de HW 00:23:5a:55:1b:87
inet end.: 192.168.1.101 Bcast:192.168.1.255 Masc:255.255.255.0
endereço inet6: fe80::223:5aff:fe55:1b87/64 Escopo:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Métrica:1
pacotes RX:859341 erros:0 descartados:0 excesso:0 quadro:0
Pacotes TX:506212 erros:0 descartados:0 excesso:0 portadora:0
colisões:0 txqueuelen:1000
RX bytes:1263708349 (1.2 GB) TX bytes:53461094 (53.4 MB)
IRQ:19 Endereço de E/S:0xdead
eth1 Link encap:Ethernet Endereço de HW 00:23:08:73:34:2b
endereço inet6: fe80::223:8ff:fe73:342b/64 Escopo:Link
UP BROADCAST MULTICAST MTU:1500 Métrica:1
pacotes RX:31 erros:0 descartados:0 excesso:0 quadro:341
Pacotes TX:30 erros:6 descartados:0 excesso:0 portadora:0
colisões:0 txqueuelen:1000
RX bytes:3503 (3.5 KB) TX bytes:4290 (4.2 KB)
IRQ:18
lo Link encap:Loopback Local
inet end.: 127.0.0.1 Masc:255.0.0.0
endereço inet6: ::1/128 Escopo:Máquina
UP LOOPBACK RUNNING MTU:16436 Métrica:1
pacotes RX:6 erros:0 descartados:0 excesso:0 quadro:0
Pacotes TX:6 erros:0 descartados:0 excesso:0 portadora:0
colisões:0 txqueuelen:0
RX bytes:340 (340.0 B) TX bytes:340 (340.0 B)
nm-toolNetworkManager Tool
State: connected
- Device: eth1 -----------------------------------------------------------------
Type: 802.11 WiFi
Driver: wl
State: disconnected
Default: no
HW Address: 00:23:08:73:34:2B
Capabilities:
Wireless Properties
WEP Encryption: yes
WPA Encryption: yes
WPA2 Encryption: yes
Wireless Access Points
Wireless: Infra, 00:25:86:C0:F8:F4, Freq 2462 MHz, Rate 54 Mb/s, Strength 20 WPA WPA2
MCCOMPUT2015: Infra, 00:25:86:B3:D4:5C, Freq 2437 MHz, Rate 54 Mb/s, Strength 100 WPA WPA2
TP-LINK: Infra, D8:5D:4C:E2:C9:58, Freq 2422 MHz, Rate 0 Mb/s, Strength 40 WPA WPA2
3307: Infra, 00:E0:4B:81:BB:9C, Freq 2427 MHz, Rate 54 Mb/s, Strength 40 WPA
- Device: eth0 [Auto eth0] ----------------------------------------------------
Type: Wired
Driver: sis190
State: connected
Default: yes
HW Address: 00:23:5A:55:1B:87
Capabilities:
Carrier Detect: yes
Speed: 100 Mb/s
Wired Properties
Carrier: on
IPv4 Settings:
Address: 192.168.1.101
Prefix: 24 (255.255.255.0)
Gateway: 192.168.1.1
DNS: 200.175.89.139
DNS: 200.175.5.139
Aproveitando a sujestão do Paulo Correa no post "
http://ubuntuforum-br.org/index.php/topic,86313.0.html".