Olá
O GsmartControl retornou com erros na verificacão curta. todas as entradas apresentaram problemas, com exceção de duas, que foram abortadas: 'completed with failure'. Não sei como repassar toda a informação aqui.
Device: /dev/sda Model: WDC WD5000LPVX-75V0TT0
Complete selective self-test log:
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
sudo fdisk -l
Disk /dev/sda: 500.1 GB, 500107862016 bytes
255 heads, 63 sectors/track, 60801 cylinders, total 976773168 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes
Disk identifier: 0x25408c5b
Device Boot Start End Blocks Id System
/dev/sda1 1 976773167 488386583+ ee GPT
Partition 1 does not start on physical sector boundary.
Disk /dev/sdb: 15.6 GB, 15631122432 bytes
255 heads, 63 sectors/track, 1900 cylinders, total 30529536 sectors
Units = sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disk identifier: 0x00032f36
Device Boot Start End Blocks Id System
/dev/sdb1 * 2048 30529535 15263744 c W95 FAT32 (LBA)
ubuntu@ubuntu:~$ sudo df -hT
Filesystem Type Size Used Avail Use% Mounted on
udev devtmpfs 1.9G 4.0K 1.9G 1% /dev
tmpfs tmpfs 387M 1.4M 385M 1% /run
/dev/sdb1 vfat 15G 5.2G 9.4G 36% /cdrom
/dev/loop0 squashfs 1008M 1008M 0 100% /rofs
/cow overlay 1.9G 353M 1.6G 19% /
none tmpfs 4.0K 0 4.0K 0% /sys/fs/cgroup
tmpfs tmpfs 1.9G 1.2M 1.9G 1% /tmp
none tmpfs 5.0M 0 5.0M 0% /run/lock
none tmpfs 1.9G 80K 1.9G 1% /run/shm
none tmpfs 100M 84K 100M 1% /run/user
ubuntu@ubuntu:~$
Eu não sei o que colocar na parte em negrito do código abaixo. Embora eu esteja aqui, não sou muito avançado, mas também não sou iniciante.
sudo fsck.ext4 -f -D /dev/ponto_de_montagem_do_seu_HD
Obrigado!