Boas,
eu estou com um problema no meu portatil.
Eu tenho um Packard Bell MX65-004 e o problema é que a minha placa wireless que é: Intel(R) PRO/Wireless 3945ABG/BG não funciona.
Quando utilizava a versão Ubuntu 7.10 a placa funciona bem ligava a qualquer rede e até o botão on/off trabalhava normalmente, neste momento instalei a versão Ubuntu 8.10 Intrepid funciona tudo menos a placa wireless, ist é detecta as redes abertas e ou protegidas mas quando tento me conectar a elas nada..... se for aberta fica sempre a dizer: obtendo ip... ao fim de algum tempo diz que não conseguiu conectar há rede, se for protegida por WPA2 (que é o caso da minha), também não conecta ao fim de algum tempo há espera aparece sempre a caixa de dialogo para eu introduzir a palavra passe, faço isso mas torna a aparecer a mesma coisa e a palavra passe que introduzo não fica memorizada.
Não sei se isto tem algum problema ou se é da minha pouca experiência que tenho em linux.Aqui fica alguma informação se servir para algo:
lipec@bell-laptop:~$ uname -a
Linux bell-laptop 2.6.27-11-generic i686 GNU/Linux
lipec@bell-laptop:~$ lspci
00:00.0 Host bridge: Intel Corporation Mobile 945GM/PM/GMS, 943/940GML and 945GT Express Memory Controller Hub (rev 03)
00:01.0 PCI bridge: Intel Corporation Mobile 945GM/PM/GMS, 943/940GML and 945GT Express PCI Express Root Port (rev 03)
00:1b.0 Audio device: Intel Corporation 82801G (ICH7 Family) High Definition Audio Controller (rev 02)
00:1c.0 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 1 (rev 02)
00:1c.1 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 2 (rev 02)
00:1c.2 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 3 (rev 02)
00:1d.0 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #1 (rev 02)
00:1d.1 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #2 (rev 02)
00:1d.2 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #3 (rev 02)
00:1d.3 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #4 (rev 02)
00:1d.7 USB Controller: Intel Corporation 82801G (ICH7 Family) USB2 EHCI Controller (rev 02)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev e2)
00:1f.0 ISA bridge: Intel Corporation 82801GBM (ICH7-M) LPC Interface Bridge (rev 02)
00:1f.1 IDE interface: Intel Corporation 82801G (ICH7 Family) IDE Controller (rev 02)
01:00.0 VGA compatible controller: nVidia Corporation G72M [Quadro NVS 110M/GeForce Go 7300] (rev a1)
03:00.0 Network controller: Intel Corporation PRO/Wireless 3945ABG [Golan] Network Connection (rev 02)
06:01.0 FireWire (IEEE 1394): Ricoh Co Ltd R5C832 IEEE 1394 Controller
06:01.1 SD Host controller: Ricoh Co Ltd R5C822 SD/SDIO/MMC/MS/MSPro Host Adapter (rev 19)
06:01.2 System peripheral: Ricoh Co Ltd R5C843 MMC Host Controller (rev 01)
06:01.3 System peripheral: Ricoh Co Ltd R5C592 Memory Stick Bus Host Adapter (rev 0a)
06:01.4 System peripheral: Ricoh Co Ltd xD-Picture Card Controller (rev 05)
06:07.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+ (rev 10)
lipec@bell-laptop:~$ iwlist scan
lo Interface doesn't support scanning.
eth0 Interface doesn't support scanning.
wmaster0 Interface doesn't support scanning.
wlan0 Scan completed :
Cell 01 - Address: 00:19:56:3a:db:80
ESSID:"XPTO"
Mode:Master
Channel:3
Frequency:2.422 GHz (Channel 3)
Quality=96/100 Signal level:-30 dBm Noise level=-127 dBm
Encryption key: off
IE: Unknown: 000750542D57494649
IE: Unknown: 010882848B0C12961824
IE: Unknown: 030103
IE: Unknown: 050400020000
IE: Unknown: 0706505420010D11
IE: Unknown: 2A0100
IE: Unknown: 32023048
IE: Unknown: DD1600409604000706A4000022A400004143000061320000
IE: Unknown: DD050040960301
Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 6 Mb/s; 9 Mb/s
11 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s; 36 Mb/s
Extra:tsf=0000001db4957181
Extra: Last beacon: 204ms ago
pan0 Interface doesn't support scanning.
lipec@bell-laptop:~$ ifconfig
wlan0 Link encap:Ethernet HWaddr 00:13:02:de:9b:6f
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
lipec@bell-laptop:~$ dmesg | grep Network
[19.689544] iwl3945: Intel(R) PRO/Wireless 3945ABG/BG Network Connection driver for Linux, 1.2.26ks
lipec@bell-laptop:~$ dmesg | grep iwl
[ 19.998069] iwl3945: Intel(R) PRO/Wireless 3945ABG/BG Network Connection driver for Linux, 1.2.26ks
[ 19.998081] iwl3945: Copyright(c) 2003-2009 Intel Corporation
[ 19.998258] iwl3945 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 19.998279] iwl3945 0000:03:00.0: setting latency timer to 64
[ 20.060412] iwl3945 0000:03:00.0: Tunable channels: 13 802.11bg, 23 802.11a channels
[ 20.060424] iwl3945 0000:03:00.0: Detected Intel Wireless WiFi Link 3945ABG
[ 20.126017] iwl3945 0000:03:00.0: PCI INT A disabled
[ 20.148707] phy0: Selected rate control algorithm 'iwl-3945-rs'
[ 37.240647] iwl3945 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 37.240797] iwl3945 0000:03:00.0: restoring config space at offset 0x1 (was 0x100002, writing 0x100006)
[ 37.241089] firmware: requesting iwlwifi-3945-2.ucode
[ 37.955414] iwl3945 0000:03:00.0: iwlwifi-3945-2.ucode firmware file req failed: -2
[ 37.955418] firmware: requesting iwlwifi-3945-1.ucode
[ 38.001037] iwl3945 0000:03:00.0: Loaded firmware iwlwifi-3945-1.ucode, which is deprecated. Please use API v2 instead.
[ 38.001042] iwl3945 0000:03:00.0: Firmware has old API version. Expected 2, got 1. New firmware can be obtained from http://www.intellinuxwireless.org.
[ 38.001046] iwl3945 0000:03:00.0: loaded firmware version 2.14.1.5
[ 38.050482] Registered led device: iwl-phy0:radio
[ 38.050507] Registered led device: iwl-phy0:assoc
[ 38.050574] Registered led device: iwl-phy0:RX
[ 38.050595] Registered led device: iwl-phy0:TX
lipec@bell-laptop:~$ dmesg | grep iwl3945
[ 19.689544] iwl3945: Intel(R) PRO/Wireless 3945ABG/BG Network Connection driver for Linux, 1.2.26ks
[ 19.689555] iwl3945: Copyright(c) 2003-2009 Intel Corporation
[ 19.689719] iwl3945 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 19.689741] iwl3945 0000:03:00.0: setting latency timer to 64
[ 19.750466] iwl3945 0000:03:00.0: Tunable channels: 13 802.11bg, 23 802.11a channels
[ 19.750479] iwl3945 0000:03:00.0: Detected Intel Wireless WiFi Link 3945ABG
[ 19.751858] iwl3945 0000:03:00.0: PCI INT A disabled
[ 36.589661] iwl3945 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[ 36.589810] iwl3945 0000:03:00.0: restoring config space at offset 0x1 (was 0x100002, writing 0x100006)
[ 36.666989] iwl3945 0000:03:00.0: iwlwifi-3945-2.ucode firmware file req failed: -2
[ 36.702594] iwl3945 0000:03:00.0: Loaded firmware iwlwifi-3945-1.ucode, which is deprecated. Please use API v2 instead.
[ 36.702605] iwl3945 0000:03:00.0: Firmware has old API version. Expected 2, got 1. New firmware can be obtained from http://www.intellinuxwireless.org.
[ 36.702613] iwl3945 0000:03:00.0: loaded firmware version 2.14.1.5
lipec@bell-laptop:~$ lshw -C network
WARNING: you should run this program as super-user.
*-network
description: Wireless interface
product: PRO/Wireless 3945ABG [Golan] Network Connection
vendor: Intel Corporation
physical id: 0
bus info: pci@0000:03:00.0
logical name: wmaster0
version: 02
serial: 00:13:02:de:9b:6f
width: 32 bits
clock: 33MHz
capabilities: bus_master cap_list logical ethernet physical wireless
configuration: broadcast=yes driver=iwl3945 latency=0 module=iwl3945 multicast=yes wireless=IEEE 802.11abg
Agradeço desde já qualquer ajuda que me possam dar referente ao meu problema
Tópico: Problemas com Intel(R) PRO/Wireless 3945ABG/BG (Lida 1912 vezes)